Features:? BASF mainly using imported raw materials, and with a variety of inorganic coatings and chemical additives prepared from the two-component waterproof coating. ? Product can directly penetrate the substrate pores, positive side effect is the same excellent and dorsal surface of the water. ? Construction in the wet surface, good air permeability. ? Both strength and flexibility characteristics, non-toxic, can be directly used for drinking water, pool water, strong adhesion. ? Anti-permeability, brushing and smooth, saving quantity. ? Product moisture, mildew resistance, weather resistance, and can be done directly in the subsequent construction of the base surface. Use:? Dedicated to building projects covering layer and the insulating layer of the whole roof, slope roof, exterior walls and basement waterproofing, suitable for kitchen, bathroom, bridges, ponds, dams, water works. Dosage:? Flat base surface 1.3-2kg / m2. Construction method:? Clean base surface, the eradication of loose parts remain flat solid. Holes, trachoma, yin and yang angle and the nozzle side to be with cement mortar or rain water does not drain, plugging Wang blocking smooth, edge angle or cracking first with non-woven polyester fabric with a high elastic acrylic waterproof coating cracking Paste woven doing reinforcing layer had finished cloth after brushing 2-3 times can be. High temperatures or dry base surface, application of water to fully wet to no clear water prevail. (Construction of high-temperature days, while brushing edges should be sprayed with fine water). ? The slurry is poured into the mixing bucket, pour the powder with a mixer while stirring, until no powder full, no precipitation pasty stand for a few minutes can be used in stir slightly. Such as slurry thickening or partial care brush, be appropriate to add no more than 5% of the total amount of water, stir well before using. ? With a brush or roller brush to deal directly good base surface, can not leak brush. If brushing pores, the gas discharge should be repeated brushing, brushing finished the first pass, let it dry sticky, then turn staggered brushing the second time, so repeated at least two to three times, each time The thickness does not exceed 0.8mm. ? Base coat brushing after 24 hours, no leakage test to test the water before making a coating or other follow-up construction to avoid future rework. Note:? Read the packaging carefully before using content description? Can not be below 0 ℃ or have clear water, rain, construction, mixing a good slurry should be used within 2 hours, overtime Never add water reuse? Air is too moist or dried solid barrier is relatively slow, ventilation equipment should be used to speed up the waterproof layer to dry? wall tile paste dries required, it is best to use rain stopped production of special tile adhesive stickers, avoid hollowing or fall off. Storage:? This product is stored in a cool dry place, unopened extended without exception can be stored for two years can still be used. ? Main components: acrylic, cement-based aggregates. Packing: 5kg, 18kg, 43kg